Movincool CM 25 Manual de Serviço descarregar pdf (Página 43)

Repair Section

6. TROUBLESHOOTING

WARNING

• Disconnect power supply from the unit before performing any service. Beware that some

residual voltages may remain in the unit immediately after the power is disconnected.

6.1 Troubleshooting

• Before troubleshooting the system, the following inspection should be performed.

(1) Inspection of power source voltage

• Check the voltage of the power source.

- Single-phase 208/230 V (60 Hz)

• Check the operation and condition of the fuse or circuit breaker in the power source.

(2) Inspection of air filters

• Remove the air filters and check the element. If the element is dirty, wash it as described in the

OPERATION MANUAL supplied with the unit.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 88 89

SERVICE MANUAL 1
Nameplate Label 2
Table of Contents 3
Repair Section 5
1. PRECAUTIONS FOR SAFETY 6
2. SPECIFICATIONS 7
2.2 Technical Specifications 8
2.3 Characteristics 10
(2) Cooling capacity curve 11
(3) Power consumption curve 12
(4) Current consumption curve 13
< NOTE > 14
3. CONSTRUCTION 15
3.2 Internal Structure 16
3.4 Air Flow 17
3.3 Basic Construction 17
4. REFRIGERATION SYSTEM 18
Operation Section 19
4.2 Compressor 20
(3) Operation 21
4.3 Condenser 22
4.5 Evaporator 23
4.6 Accumulator 24
4.7 High-Pressure Switch 24
5. ELECTRICAL SYSTEM 25
5.2 Control Box 26
5.3 Power Supply Requirements 27
LCD Display 29
Unit Terminal 33
Warning Device 33
Relay Output Contactor 33
Fire Alarm Device 34
Open Dry Contact 34
5.8 Basic Operation 35
5.9 Compressor Operation 35
(1) When the WMC is connected 36
(2) When the MWT is connected 36
5.14 Anti-Frost Control 37
(Automatic Recovery Function) 37
5.17 Relay Board 38
12 12341234 39
DSW1 DSW2 DSW3 DSW4 39
5.18 Compressor 40
5.19 Fan Motor 41
5.20 Temperature Thermistor 42
5.21 Float Switch 42
6. TROUBLESHOOTING 43
6.2 Self-Diagnostic Codes 44
Alarm (buzzer) patterns 47
Alarm clear method 48
6.3 Troubleshooting Chart 50
(1) Display method 57
6.7 Initialize Fan Motor 61
6.8 TEST Mode 63
6.9 Basic Inspection 64
6.10 Inspection of Compressor 65
Temp.°F (°C) 66
(2) Refrigerant leak 67
(3) Insufficient refrigerant 67
7. DISASSEMBLY 68
7.2 Disassembly 69
(1) Relay board 76
(1) Proper brazing techniques 78
(4) Use of dry nitrogen gas 79
(5) Vertical joints 79
(2) Evacuation 82
(3) Checking vacuum 83
Refrigerant 84
Cylinder R-410A 84
(5) Evacuation (repeat) 85
(2) Removal of gauge manifold 87
9. REASSEMBLY 88

Comentários a estes Manuais

Sem comentários

Movincool CM 25 Manual de Serviço Página 43

Comentários a estes Manuais

Manuais e produtos relacionados com Vbombas de água Movincool CM 25